Learn how to replace or install your generator.
Required materials: new generator, Torx T20 screwdriver.
Instructions
- Step 1 :
- Turn off the device and unplug the power cable before any handling.
- Step 2 :
- Open both doors and remove the two front screws located under the top cover (on NOVVEN 3 only).
- Step 3 :
- Remove all screws located on the top cover.
- Step 4 :
- Slide the cover forward a few centimeters, then lift it completely off the cabinet.
- Step 5 :
- After locating your generator, remove the four screws from the lower mounting brackets (not the upper ones).
- Step 6 :
- Gently disconnect the three connectors from the electronic board (do not pull on the wires).
- Step 7 :
- Disconnect the flexible hose from the ventilation unit.
- Step 8 :
- Pull all generator wires out through the cable gland.
- Step 9 :
- Remove the generator from the technical compartment, making sure no wires are trapped.
- Step 10 :
- Take the new generator out of its packaging and screw it in place using four screws at the bottom.
- Step 11 :
- Carefully reconnect the three connectors (see video for connection orientation) to the electronic board, routing them through the cable gland if needed.
- Step 12 :
- Reconnect the hose to the main ventilation unit and secure it with a cable tie.
- Step 13 :
- Reposition the top cover.
- Step 14 :
- Screw the cover back on at the top.
- Step 15 :
- Reinstall the two front screws under the cover (on NOVVEN 3 only).
- Step 16 :
- Place the used generator in the new one’s packaging and return it to JVD for recycling.